Spark + Minilogic E-type (Thermopatch) labelprinter
===================================================

For this printer use the printer-driver:
Epson LQ-870 ESC PS/2

If another driver is used like the 'Epson LQ-860' the printer is not cutting the labels.

Special notes:
--------------

1) When you are using Windows 2000/XP in combination with Spark + Minilogic E, please note the following:
- Set the printer-quality to '360 x 180' in the printer-driver. If not the barcodes will be printed
very badly!

2) When you are using Windows 2000/XP in combination with Spark + Minilogic E, please note the following:
- The EPROM-version for the Minilogic-printer must be at least 5.6! If older, it can result
in problems like 'not cutting'.
If in doubt, please contact Thermopatch about the correct EPROM-version.

3) The paper-height can have a minimum height of 1.26 CM when using Windows 98. But
when you are using Windows 2000/XP the minimum height is 2.54 CM!

For questions about the printer itself, please contact Thermopatch.